Freeflex
SUMMARY OF PRODUCT CHARACTERISTICS
1 NAME OF THE MEDICINAL PRODUCT
Sodium Chloride 0.18% and Glucose 4% Infusion BP Polyfusor as Steriflex No. 18 or freeflex
2 QUALITATIVE AND QUANTITATIVE COMPOSITION
|
Name |
% (w/v) |
g/l |
|
Sodium Chloride |
0.18 |
1.80 |
|
Glucose Monohydrate |
4.4 |
44.00 |
|
(Equivalent to Anhydrous Glucose) |
4.0 |
40.00 |
Each ml contains 1.8 mg sodium chloride and 40 mg glucose (as monohydrate).
Mmol/l (approx.): Na+: 30 Cl-: 30
Approximately: 668 kJ/l (or 160kcal)
For the full list of excipients, see section 6.1.
3 PHARMACEUTICAL FORM
Intravenous fluid.
The solution is clear and colourless or faintly straw coloured and practically free from particles. pH range 3.5-6.5
Osmolarity approximately 283 mOsmol/L.
4 CLINICAL PARTICULARS
4.1 Therapeutic indications
An isotonic solution for maintenance treatment of dehydration with carbohydrate loss.
4.2 Posology and method of administration
Posology
The dosage of this solution depends on the age, weight, clinical and biological (acid-base balance) conditions of the patient, concomitant therapy and in particular the patient's hydration state.
Adults
For routine maintenance, normal daily fluid and electrolyte requirements are 25-30 ml/kg/day water, 1 mmol/kg/day sodium, and 50-100 g/day glucose (1.25 - 2.5 L of 4% glucose). The maximum rate of glucose oxidation is approximately 0.8 g/kg/h (20 ml/kg/h of 4% glucose), but may be only half this in critically ill patients. To avoid hyperglycaemia and other metabolic complications, the infusion rate of glucose should generally be in the range 0.12-0.24 g/kg/h (3-6 ml/kg/h), with a maximum of 0.30 g/kg/h (7.5 ml/kg/h).
Elderly
A reduced volume and rate of infusion may be necessary to avoid circulatory overload.
Patients with cardiac and renal impairment
A reduced volume and rate of infusion may be necessary to avoid circulatory overload.
Paediatric Population
Use of Sodium Chloride 0.18% and Glucose 4% Solution is restricted to specialist paediatric settings such as renal, liver, cardiac, high dependency or intensive care units, where there is expert medical supervision.
The dosage depends on the age, weight, clinical and biological (acid-base balance) conditions of the patient, and concomitant therapy and should be determined by the expert. The child must be carefully monitored throughout treatment.
Method of administration Intravenous use.
Monitoring
Adequate urine flow must be ensured and careful monitoring of fluid balance, plasma and urinary electrolyte concentrations are essential.
4.3 Contraindications
• Hypersensitivity to the active substances or to any of the excipients listed in section 6.1.
• Hyperhydration states
• Hyponatraemia
• Acute ischaemic stroke
Head trauma (first 24 hours) Rehydration in hyperemesis gravidarum.
4.4 Special warnings and precautions for use
When used for routine maintenance, a source of potassium to meet daily needs (1 mmol/kg/day) may be required.
Sodium Chloride 0.18% and Glucose 4% should not be administered rapidly or for prolonged periods particularly in infants and the elderly. In potassium deficient patients, administration of Sodium Chloride 0.18% and Glucose 4% will increase potassium loss, potassium supplements should also be administered.
Sodium Chloride 0.18% and Glucose 4% should be administered with caution in patients with conditions associated with sodium retention and/or with complex fluid and/or electrolyte redistribution issues or imbalances, or significant comorbidity, including:
• obesity
• older or frail patients
• gross oedema
• severe sepsis
• hypernatraemia
• renal, liver and/or cardiac impairment
• post-operative fluid retention and redistribution
• malnourished and refeeding issues
• pregnancy, especially in the presence of (pre-) eclampsia
• hypertension
Sodium Chloride 0.18% and Glucose 4% should be administered with caution in patients with diabetes mellitus; the amount of infused glucose should be calculated and insulin requirements modified as appropriate. Serum potassium may also need adjustment.
Patients receiving fluid replacement therapy should be monitored. During the catabolic phase of the response to illness or injury, there is an increase in antidiuretic hormone, cortisol, and aldosterone secretion, especially if there has been any reduction in blood or extracellular fluid volume. These lead to retention of sodium and water and loss of potassium, which should be accounted for when administering a hypotonic solution. Children, the elderly, patients on diuretics and those with Syndrome of Inappropriate Antidiuretic Hormone (SIADH) problems are at particular risk of developing significant hyponatraemia, especially if too much Sodium Chloride 0.18% and Glucose 4% is given or the infusion is given too rapidly. Clinical monitoring should include checks of serum electrolytes (including potassium), glucose level, and the acid-base and water balance. Inadequate monitoring may lead to fluid and electrolyte disturbances such as hyponatraemia. Hyponatraemia can lead to headache, nausea, seizures, lethargy, coma, cerebral oedema and death, therefore acute symptomatic hyponatraemic encephalopathy is considered a medical emergency.
Paediatric Population
Use of Sodium Chloride 0.18% and Glucose 4% Solution in the paediatric population <16 years of age is restricted to specialist paediatric settings under expert medical supervision. The dosage depends on the age, weight, clinical and biological (acid-base balance) conditions of the patient, concomitant therapy and should be determined by the expert.
4.5 Interaction with other medicinal products and other forms of interaction
Concomitant corticosteroid use should be taken into consideration before administering Sodium Chloride 0.18% and Glucose 4%. Medicinal products with mineralocorticoid activity may cause hypertension, and sodium and water retention. Medicinal products with glucocorticoid activity may increase serum glucose.
Hypotonic intravenous solutions containing glucose, may cause haemolysis of red cells. Like all solutions for infusion, this product should not be coadministered via an infusion line that is being used for a blood component. Administration through a different lumen of a multi-lumen central venous access device is generally safe. Use of flushing administration sets for the transfusion of blood products is generally not recommended.
4.6 Fertility, pregnancy and lactation
The safety of this solution during pregnancy and lactation has not been assessed, but its use during these periods is not considered to constitute a hazard.
4.7 Effects on ability to drive and use machines
The product has no influence on the ability to drive or use machines.
4.8 Undesirable Effects
Thrombosis of the chosen vein may occur with intravenous infusion. If the infusion is protracted then another vein should be selected after 12 to 24 hours.
Other adverse reactions related to the potentially low pH (range 3.5-6.6) of Sodium Chloride 0.18% and Glucose 4% include venous irritation and thrombophlebitis.
Unduly rapid, or excessive, administration may lead to pulmonary oedema.
Post Marketing Adverse reactions: Metabolism and nutrition disorders -severe hyponatraemia, which could lead to death, has been reported.
Reporting of suspected adverse reactions
Reporting suspected adverse reactions after authorisation of the medicinal product is important. It allows the continued monitoring of the benefit/risk balance of the medicinal product. Healthcare professionals are asked to report any suspected adverse reactions via the Yellow Card Scheme at: www.mhra.gov.uk/yellowcard.
4.9 Overdose
Overdosage may lead to fluid overload, electrolyte imbalances, changes in acid-base balance, and possibly hyperglycaemia. The risk of significant hyponatraemia is increased if too much fluid is given or the infusion is given too rapidly; this risk is particularly high in children, the elderly, patients on diuretics, and those with SIADH problems. Patients with renal impairment or cardiac failure are at increased risk of fluid overload. Hyperglycaemia may occur, especially in patients with diabetes mellitus, which may need to be treated with insulin.
Electrolyte disturbances may need to be treated with either sodium-free or sodium containing intravenous fluids.
In the event of overdose, consideration should be given to discontinuing or temporarily interrupting treatment. The relevant symptomatic and supportive measures should be provided as necessary.
5 PHARMACOLOGICAL PROPERTIES
5.1 Pharmacodynamic properties
Pharmacotherapeutic group: Electrolytes with carbohydrates ATC code: B05BB02
The pharmacodynamic properties of the solution are those of its components:
• sodium chloride provides a source of sodium and chloride ions to maintain the osmotic tension of the extracellular fluid and tissues.
• glucose is a monosaccharide which provides a source of energy.
5.2 Pharmacokinetic properties
The pharmacokinetic properties of Sodium Chloride 0.18% & Glucose 4% solution are those of its composition (sodium, chloride, glucose).
Intravenous administration of the solution provides an immediate supply of electrolytes to blood.
After injection of radiolabelled sodium (24Na), the half-life is 11 to 13 days for 99% of the injected Na and one year for the remaining 1%. The distribution varies depending on the tissues: it is relatively fast in muscles, liver, kidney, cartilage and skin; slower in erythrocytes and neurons; very slow in bone. Sodium is predominantly excreted by the kidney, but there is extensive renal reabsorption. Small amounts of sodium are lost in the faeces and sweat.
Glucose is metabolised via pyruvic or lactic acid to carbon dioxide and water with the release of energy. All body cells are capable of oxidising glucose and it forms the principal source of energy in cellular metabolism.
5.3 Preclinical safety data
Preclinical safety data of Sodium Chloride 0.18% and Glucose 4% solution in animals are not relevant since sodium chloride and glucose are physiological components of the body.
6 PHARMACEUTICAL PARTICULARS
6.1 List of excipients
Water for injections Hydrochloric acid Sodium hydroxide
6.2 Incompatibilities
Compatibility of the medicinal product to be added to Sodium Chloride 0.18% and Glucose 4% solution must be assessed before addition.
In the absence of compatibility studies, this medicinal product must not be mixed with other medicinal products. Reference should be made to the Summary of Product Characteristics for the additive medicine.
Those additives known to be incompatible should not be used.
As a guidance, the following medications are incompatible with the Sodium Chloride 0.18 % and Glucose 4% Solution (non-exhaustive listing):
• amiodarone
• amphotericin B
• ampicillin sodium
• amsacrine
• erythromycin lactobionate (unless the Sodium Chloride 0.18 % and Glucose 4% solution is buffered)
• sodium nitroprusside.
Because of the presence of glucose, Sodium Chloride 0.18% and Glucose 4% solution should not be administered through the same infusion equipment as whole blood, as haemolysis and clumping can occur.
Because of the nature of the plastic material of the bag (PVC), this solution should not be used as a vehicle for the administration of drugs which may be sorbed to the surface of the bag to varying and significant degrees.
6.3 Shelf life
500 & 1000 ml PVC Bags - 2 years.
500 & 1000 ml Polyolefin Bags - 3 years.
6.4 Special precautions for storage
Store below 25°C
6.5. Nature and Contents of Container
The container is a flexible bag made of medical grade PVC.
a) A hermetically sealed polythene bag.
b) A rectangular pouch consisting of polyamide/polythene composite
c) Polyamide/Polyethylene-Propylene composite laminate welded to polypropylene ethylene propylene composite, plugged with a polycarbonate plug with either a bromobutyl (West 4481/45) or gum (West 7006/45) stopper.
Or
A flexible polyolefine bag sealed in a polyolefine overwrap.
6.6 Special precautions for disposal
Use only if the solution is clear, without visible particles and if the container is undamaged. Sodium Chloride 0.18% and Glucose 4% solution should be administered with sterile equipment using an aseptic technique.
Compatibility of the medicinal product to be added to Sodium Chloride 0.18% and Glucose 4% solution must be assessed before addition. If medications are added, care should be taken to maintain aseptic conditions and ensure complete mixing. Once a medicine is added to Sodium Chloride 0.18% and Glucose 4% solution, the mixture must be administered immediately.
Opening the overwrap:
Locate the corner tabs at the end of the bag. Grip the two tabs and pull the two halves of the overwrap apart, releasing the bag onto a clean surface.
Setting up the solution:
Position the roller clamp of the giving-set to just below the drip chamber and close. Hold the base of the giving set port firmly and grip the wings of the twist of tab. Twist to remove the protective cover. Still holding the base of the giving-set port push the set spike fully into the port to ensure a leak proof connection. Prime the set in accordance with the manufacturer’s instructions.
7 MARKETING AUTHORISATION HOLDER
Fresenius Kabi Limited Cestrian Court Eastgate Way Manor Park Runcorn Cheshire WA7 1NT UK
8. MARKETING AUTHORIZATION NUMBER
PL 08828/0069
9 DATE OF FIRST AUTHORISATION/RENEWAL OF THE AUTHORISATION
Date of first authorisation: 05 June 1989 Date of latest renewal: 26 February 2009
10 DATE OF REVISION OF THE TEXT
23/05/2016